The rate of photosynthesis in a plant can be measured with the following simple experiment.
1. Set up the apparatus above, placing the funnel upside down in the beaker. However, do not insert the measuring tube into the beaker until the pondweed has adjusted
2. Cut a piece of pondweed around 7 cm long and use forceps to place it in the beaker.
3. Using a ruler, place the lamp 15 cm away from the beaker containing the pondweed. The lamp does not have to be placed like it is in the diagram, as long as it is directed at the pondweed in the beaker
4. Leave the apparatus for around 10 minutes to allow the pondweed to adjust.
5. Position the boiling tube upside down in the beaker, over the upside-down funnel. We will use the boiling tube to count the number of bubbles released, which is oxygen gas
6. Count the number of bubbles in the boiling tube after one minute
7. Repeat the count five times, recording your results in a table, such as the one below:
|Distance||Number of bubbles (1)||Number of bubbles (2)||Number of bubbles (3)|
8. Repeat the experiment at different distances from the lamp
9. Plot the results on a graph to see a pattern or trend
Alternatively, you can use a gas syringe to measure the volume of oxygen produced by the pondweed, instead of counting bubbles. This will give you more accurate results. If you decide to take this approach, you can plot a graph:
Independent variable – The distance from the lamp (light intensity)
Dependent variable – The number of bubbles (oxygen) produced per minute
Control variables – Maintain a consistent temperature and use the same piece of pondweed throughout.
Ensure your hands are dry before handling the lamp to prevent electric shocks.