To prepare a pure, dry sample of a soluble salt from an insoluble oxide or carbonate.
1. Use a measuring cylinder to measure 50 cm³ of sulfuric acid, then pour it into the beaker.
2. Heat the acid gently using a Bunsen burner.
3. Use a spatula to add small amounts of copper oxide to the acid and stir the solution using a stirring rod until the base stops dissolving.
4. Filter the mixture using a filter funnel and filter paper to remove any unreacted copper oxide. Collect the filtrate, which contains copper sulfate, in a clean evaporating basin.
5. Place the evaporating basin in a water bath and gently heat the water using a Bunsen burner until about half of the water in the copper sulfate solution has evaporated. This will cause the solution to become more concentrated.
6. Carefully pour the concentrated solution into a clean watch glass and leave it in a warm, dry place. As the solution cools, copper sulfate crystals will start to form.
It’s important to handle all chemicals with care during the experiment, and to wear appropriate protective equipment such as goggles and a lab coat to avoid any accidents or harm. Also, do not heat the solution too quickly, as this can cause it to splatter which may result in injury.